Arms ModuleSub-assembly C (A + B)
Step 9A: Attach the Joint Plate
Align Part 300_05A with the housing seam and fasten it around the motor shaft.
Parts needed
| Part | Count |
|---|---|
| 1 | |
| M3x12 Flat Bolt | 8 |
Instructions
Now move Sub Assembly B upward so that the motor shaft is facing the ceiling.
Take part and align it with the holes on the surface of Sub Assembly B around the motor shaft. Part has 2 protrusion on its edge, it is important that this protrusion align with the seam where the two Part and joined together. Make sure this is positioned correctly, else your arm will be locked wrongly.
Take 8 – M3x12 Flat Bolts, one by one, tighten it lightly in the 8 hole of Part to Sub Assembly B. Make sure the parts are aligned.
Once the part is aligned, remove each M3x12 flat bolts, put thread locker on them, and tighten them back in, and then repeat for the next bolt.
How is this guide?