Verify Factory Preparation

Verify installed inserts, premade wiring, finished parts, and factory-labeled actuator IDs.

Asimov DIY Kit path

This is a verification step. Do not perform normal self-source fabrication, insert installation, harness manufacturing, or actuator-ID programming.

Mechanical Parts and Inserts

For each part:

confirm the part number and left or right side

inspect the finish for shipping damage

inspect for cracks, deformation, blocked holes, or damaged mating surfaces

confirm every required heat-set insert is present

confirm inserts are straight, fully seated, and surrounded by undamaged material

quarantine a part with a missing, loose, tilted, or damaged insert

Insert sizes, quantities, depths, acceptance criteria, and an equivalent textual location map remain TBC. The images below are visual references only and cannot serve as the sole acceptance record.

Torso and Pelvis Insert Locations

Arm Insert Locations

Leg and Head Insert Locations

Premade Wiring

For each normal supplied harness:

match its identity to the released Kit wire manifest

confirm quantity, nominal length, and endpoints

inspect connector housings, terminals, latches, insulation, and strain relief

quarantine cut, pinched, exposed, loose, contaminated, or heat-damaged wiring

Do not cut, re-terminate, or remake a normal Kit harness. Keep Wago and soldered pass-through wires unjoined for their assembly steps.

TBC: Kit wire manifest

The released Kit wire manifest and exact Wago and soldered exception specifications are TBC.

Numbered Actuators

confirm all 25 actuators have visible, unique stickers numbered 1 through 25

match each model and sticker to the current Motor ID allocation

record the serial number, model, target Motor ID, and intended location

quarantine missing, duplicate, damaged, or inconsistent stickers

The sticker defines the target Motor ID. Every Kit buyer programs and reads back each actuator during common Software and Motor Setup.