Step 4: Attach Part 500_06A
Fit part 500_06A over actuator ID 10 and fasten it to the existing assembly.
Parts needed
| Part | Count |
|---|---|
| Current assembly from Step 3 | 1 |
| 1 | |
| M4x14 Flat bolt | 6 |
| M3x12 Flat bolt | 6 |
| M3x20 Socket bolt | 1 |
| Threadlocker | As needed |
Instructions
Lay the current assembly flat such that the part is facing downward toward the surface and the actuator shaft is facing towards the ceiling.
Take part and align it with the actuator and part such that the actuator fits into the round hollow in part and the 6 holes on the handle align with part threaded insert.
Take 6 – M3x12 Flat bolt and lightly tighten into the 6 holes along the circumference of the round portion of part that is fitting on to the actuator to align the parts.
After the parts are aligned:
- remove each of the 6 – M3x12 Flat bolts in a star formation,
- apply threadlocker,
- then tighten them back to secure part to the actuator.
Take 6 – M4x14 flat bolt and lightly tighten into the 6 holes on the long portion of part that align with the threaded insert on part to align the two parts together.
After the parts are aligned:
- remove each of the 6 – M4x14 flat bolts,
- apply threadlocker,
- then tighten them back to secure part to part .
Take 1 – M3x20 socket bolt, apply threadlocker and tighten it into the singular hole at the very edge of the circumference of part to secure it to part .
How is this guide?