Step 5: Assemble the Battery Enclosure
Assemble battery 100_11X and its connector hardware inside enclosure parts 100_10C and 100_12C.
Parts needed
| Part | Count |
|---|---|
| battery enclosure | 1 |
| enclosure cover | 1 |
| battery with attached cable and connector | 1 |
| 1 | |
| 1 | |
| M4x8 socket bolts | 4 |
| Threadlocker | As needed |
Instructions
Place part such that the hollow portion is facing upward toward the ceiling.
Take the battery (part ) and slowly lower it into the hollow portion of part , the cable should be on the opposite side of the cable cut out on part . Route the battery cable toward the cut out as shown below.
Connect the battery-cable connector to part , then insert the connected component into the protruding mount at the back of part .
Take part and align it with part such that all the holes on part and align with the threaded insert on part . Careful not to squeeze the battery cable.
Take 4 - M4x8 Socket bolt and tighten it into each of the four holes to secure part and part together.
After the parts are aligned:
- remove each of the 4 – M4x8 socket bolts in a star formation,
- apply threadlocker,
- then tighten them back to secure Part and part together.
Take part and installed it through the round hole on part .
How is this guide?