Step 10: Install the Elbow Actuator and Route Its Cables
Connect the XT30 cable connectors to actuator ID 16, seat it in part 400_15C, and route both cables through their designated openings.
Parts needed
| Part | Count |
|---|---|
| EC-A4310-P2-36 (ID 16) | 1 |
| Single-ended XT30 (2+2) - 100mm | 1 |
| Double-ended XT30 (2+2) - 230mm | 1 |
| 1 |
Instructions
Connect the XT30 connector of the 100 mm single-ended cable to one port on actuator ID 16 and one connector of the 230 mm double-ended cable to the other actuator port. Put the assembly aside.
Take part and lay it flat on the surface. Make sure that the port cut out on the body is facing upward toward the ceiling. And the port cut out on the side is facing toward you.
Align actuator ID 16 with the round hole on part . Route the single-ended XT30 cable through the hollow body and the double-ended XT30 cable through the cable channel until its free connector exits the side cutout.
How is this guide?
Step 9B: Attach the Shoulder Yaw Shaft Mount
Route the cable from actuator ID 15 through part 400_06B and secure the part to the actuator shaft with six threadlocked M4x20 socket bolts.
Step 11: Attach the Elbow Housing Plates
Attach part 400_08A to part 400_15C with M4x16 flat bolts, then secure part 400_07A to part 400_15C and actuator ID 16 with threadlocked M4x16 and M3x12 flat bolts.