Step 4: Install the Speaker
Seat speaker 100_13X in the front torso opening and secure it with four socket bolts.
Parts needed
| Part | Count |
|---|---|
| Torso assembly from Step 3 | 1 |
| speaker | 1 |
| 4 | |
| 50 mm wire | 2 |
| Approved soldering and insulation supplies | As needed |
| Threadlocker | As needed |
Instructions
Take part and put it down such that the neck is facing upward toward the ceiling while the waist is pointing downward toward the surface. The hollow part should be facing away from you.
Take the speaker and a pair of 50 mm wires to solder them onto the speaker as shown in the video below.
How to solder two wires together
Take part (the speaker) and align it with the rectangular hole in front of the chest. Then, slot the speaker in the hole.
Take 4 of and lightly tighten into the 4 corner of part to align the part with Part .
After the parts are aligned:
- remove 4 of one at a time,
- apply threadlocker,
- then tighten them back to secure Part and part together.
Take the wire from the speakers and routed it through the port cut out toward the back of part .
How is this guide?
Step 3: Install the Neck Yaw Actuator
Attach neck yaw actuator ID 24 to part 100_03A, connect the 200 mm and 600 mm XT30 (2+2) cable connectors to its ports, and secure it in the torso neck.
Step 5: Attach the Arm Modules
Attach the completed left and right arm modules to the torso shell with mounting plates 100_05A and 100_08A and 24 M4x30 Socket bolts.