AssembleRight Leg ModuleThigh Assembly
Step 1: Set Up Actuator ID 9
Connect the XT30 (2+2) cable connectors to actuator ID 9, route the 280 mm cable through the actuator shaft, and leave the 150 mm cable and its free connector accessible.
Parts needed
| Part | Count |
|---|---|
| (ID 9) | 1 |
| 280 mm single-ended XT30 (2+2) cable | 1 |
| 150 mm double-ended XT30 (2+2) cable | 1 |
Instructions
Place the (ID 9) on a flat surface with the shaft facing downward toward the floor.
Connect the connector of the 280 mm single-ended XT30 (2+2) cable to the actuator port nearest the center hole, then route the cable through the hollow shaft.
Connect one connector of the 150 mm double-ended XT30 (2+2) cable to the outer actuator port, leaving the cable and its free connector accessible.
How is this guide?