Step 10: Attach the Elbow Housing Plates
Attach parts 300_08A and 300_07A to part 300_15C with threadlocked M4x16 Flat bolts, and secure part 300_07A to actuator ID 21 with threadlocked M3x12 Flat bolts.
Parts needed
| Part | Count |
|---|---|
| Elbow actuator-and-housing assembly from Step 9 | 1 |
| 1 | |
| 1 | |
| 10 | |
| 6 | |
| Threadlocker | As needed |
Instructions
Take part and align all the 5 holes on the part to fit the threaded insert on part . It should cover the actuator bottom near the port, not the actuator shaft.
Take 5 of and lightly tighten into 5 holes on part to align with part .
Flip the assembly over such that the actuator shaft is not facing toward the ceiling.
Take part and align all the 5 holes on the part to fit the threaded insert on part .
Take 6 of and lightly tighten into 6 holes on part to align with the threaded holes on the actuator.
Take 5 of and lightly tighten into 5 holes on part to align with part .
After the parts are aligned:
- remove 6 of one at a time in a star formation,
- apply threadlocker,
- then tighten them back to secure Part and the actuator together.
After the parts are aligned:
- remove 5 of one at a time,
- apply threadlocker,
- then tighten them back to secure Part and part together.
Flip the assembly over and repeat for the 5 bolts on part from Instruction 2:
- remove 5 of one at a time,
- apply threadlocker,
- then tighten them back to secure Part and part together.
How is this guide?
Step 9: Install the Elbow Actuator and Route Its Cables
Connect the XT30 (2+2) cable connectors to actuator ID 21, seat it in part 300_15C, and route both cables through their designated openings.
Step 11: Attach the Elbow Shaft Plate and Actuator Housing
Attach part 300_09A to the shaft of actuator ID 21 with six threadlocked M3x16 Flat bolts and attach part 300_16C with three threadlocked M4x10 Flat bolts.